pellimits.com
CAS 96-33-3VOC

Methyl Acrylate

OSHA PEL 10 ppm· Volatile Organic Compounds · NIOSH method NIOSH 1450

OSHA PEL (8-hr TWA)
10 ppm
Target organs
Respiratory tract; eyes; skin
Sampling method
NIOSH 1450

Methyl Acrylate (96-33-3)

Methyl Acrylate is a volatile organic compound with CAS Registry Number 96-33-3. Under the OSHA air contaminants standard (29 CFR 1910.1000), its Permissible Exposure Limit (PEL) — the legal 8-hour time-weighted average (TWA) for general industry — is 10 ppm. The principal target organs are the Respiratory tract; eyes; skin, and workplace air is sampled and analyzed by NIOSH 1450.

Exposure Limits at a Glance

Limit Value Basis
OSHA PEL (8-hr TWA) 10 ppm 29 CFR 1910.1000
NIOSH REL See note below NIOSH Pocket Guide
Hazard Class Volatile Organic Compound VOC
Target Organs Respiratory tract; eyes; skin NIOSH / OSHA
Sampling Method NIOSH 1450 NIOSH Manual of Analytical Methods

NIOSH REL note: TWA values in the ppm range; NIOSH RELs are frequently 10x stricter than the OSHA PEL. The REL is a non-regulatory recommendation; where a NIOSH REL exists it is typically more protective than the OSHA PEL.

How It Enters the Body & Health Effects

Exposure to Methyl Acrylate is assessed against the Respiratory tract; eyes; skin — the organ systems most consistently affected in occupational studies. Employers must ensure no employee’s 8-hour TWA exceeds the 10 ppm PEL, and must use engineering controls, work practices, and — where required — respiratory protection to keep exposures at or below that level.

Sampling & Compliance Notes

  1. Determine whether the exposure is a full-period 8-hour TWA or a short-term / ceiling scenario. Ceiling and STEL excursions apply to several VOC-class agents regardless of the 8-hour average.
  2. Calibrate personal sampling pumps before and after each shift and record flow rates; method NIOSH 1450 specifies media, flow, and analysis.
  3. Compare analytical results to the OSHA PEL of 10 ppm and the NIOSH REL. Document the higher of the two for internal exposure-control targets.
  4. Where the PEL includes a “skin” notation, dermal absorption can contribute to the dose — glove selection and hygiene facilities are part of compliance.

Frequently Asked Questions

What is the OSHA PEL for Methyl Acrylate?

The OSHA Permissible Exposure Limit (8-hour TWA) for Methyl Acrylate is 10 ppm.

What is the CAS number for Methyl Acrylate?

The CAS Registry Number for Methyl Acrylate is 96-33-3.

What are the target organs for Methyl Acrylate?

The primary target organs are the Respiratory tract; eyes; skin.

How do you measure Methyl Acrylate in workplace air?

Use NIOSH analytical method NIOSH 1450 for air sampling and laboratory analysis.

What hazard class is Methyl Acrylate?

It is classified here as a Volatile Organic Compound (VOC).

Related VOC chemicals

Other volatile organic compounds with lower or comparable exposure limits.