pellimits.com
CAS 108-21-4VOC

Isopropyl Acetate

OSHA PEL 250 ppm· Volatile Organic Compounds · NIOSH method NIOSH 1454

OSHA PEL (8-hr TWA)
250 ppm
Target organs
Eyes; respiratory tract; CNS
Sampling method
NIOSH 1454

Isopropyl Acetate (108-21-4)

Isopropyl Acetate is a volatile organic compound with CAS Registry Number 108-21-4. Under the OSHA air contaminants standard (29 CFR 1910.1000), its Permissible Exposure Limit (PEL) — the legal 8-hour time-weighted average (TWA) for general industry — is 250 ppm. The principal target organs are the Eyes; respiratory tract; CNS, and workplace air is sampled and analyzed by NIOSH 1454.

Exposure Limits at a Glance

Limit Value Basis
OSHA PEL (8-hr TWA) 250 ppm 29 CFR 1910.1000
NIOSH REL See note below NIOSH Pocket Guide
Hazard Class Volatile Organic Compound VOC
Target Organs Eyes; respiratory tract; CNS NIOSH / OSHA
Sampling Method NIOSH 1454 NIOSH Manual of Analytical Methods

NIOSH REL note: TWA values in the ppm range; NIOSH RELs are frequently 10x stricter than the OSHA PEL. The REL is a non-regulatory recommendation; where a NIOSH REL exists it is typically more protective than the OSHA PEL.

How It Enters the Body & Health Effects

Exposure to Isopropyl Acetate is assessed against the Eyes; respiratory tract; CNS — the organ systems most consistently affected in occupational studies. Employers must ensure no employee’s 8-hour TWA exceeds the 250 ppm PEL, and must use engineering controls, work practices, and — where required — respiratory protection to keep exposures at or below that level.

Sampling & Compliance Notes

  1. Determine whether the exposure is a full-period 8-hour TWA or a short-term / ceiling scenario. Ceiling and STEL excursions apply to several VOC-class agents regardless of the 8-hour average.
  2. Calibrate personal sampling pumps before and after each shift and record flow rates; method NIOSH 1454 specifies media, flow, and analysis.
  3. Compare analytical results to the OSHA PEL of 250 ppm and the NIOSH REL. Document the higher of the two for internal exposure-control targets.
  4. Where the PEL includes a “skin” notation, dermal absorption can contribute to the dose — glove selection and hygiene facilities are part of compliance.

Frequently Asked Questions

What is the OSHA PEL for Isopropyl Acetate?

The OSHA Permissible Exposure Limit (8-hour TWA) for Isopropyl Acetate is 250 ppm.

What is the CAS number for Isopropyl Acetate?

The CAS Registry Number for Isopropyl Acetate is 108-21-4.

What are the target organs for Isopropyl Acetate?

The primary target organs are the Eyes; respiratory tract; CNS.

How do you measure Isopropyl Acetate in workplace air?

Use NIOSH analytical method NIOSH 1454 for air sampling and laboratory analysis.

What hazard class is Isopropyl Acetate?

It is classified here as a Volatile Organic Compound (VOC).

Related VOC chemicals

Other volatile organic compounds with lower or comparable exposure limits.