pellimits.com
CAS 111-30-8Aldehyde

Glutaraldehyde

OSHA PEL 0.20 ppm· Aldehydes · NIOSH method NIOSH 2532

OSHA PEL (8-hr TWA)
0.20 ppm
Target organs
Respiratory tract; eyes; skin
Sampling method
NIOSH 2532

Glutaraldehyde (111-30-8)

Glutaraldehyde is a aldehyde with CAS Registry Number 111-30-8. Under the OSHA air contaminants standard (29 CFR 1910.1000), its Permissible Exposure Limit (PEL) — the legal 8-hour time-weighted average (TWA) for general industry — is 0.2 ppm. The principal target organs are the Respiratory tract; eyes; skin, and workplace air is sampled and analyzed by NIOSH 2532.

Exposure Limits at a Glance

Limit Value Basis
OSHA PEL (8-hr TWA) 0.2 ppm 29 CFR 1910.1000
NIOSH REL See note below NIOSH Pocket Guide
Hazard Class Aldehyde Aldehyde
Target Organs Respiratory tract; eyes; skin NIOSH / OSHA
Sampling Method NIOSH 2532 NIOSH Manual of Analytical Methods

NIOSH REL note: NIOSH RELs are stringent due to sensitization and carcinogenicity (e.g. formaldehyde). The REL is a non-regulatory recommendation; where a NIOSH REL exists it is typically more protective than the OSHA PEL.

How It Enters the Body & Health Effects

Exposure to Glutaraldehyde is assessed against the Respiratory tract; eyes; skin — the organ systems most consistently affected in occupational studies. Employers must ensure no employee’s 8-hour TWA exceeds the 0.2 ppm PEL, and must use engineering controls, work practices, and — where required — respiratory protection to keep exposures at or below that level.

Sampling & Compliance Notes

  1. Determine whether the exposure is a full-period 8-hour TWA or a short-term / ceiling scenario. Ceiling and STEL excursions apply to several Aldehyde-class agents regardless of the 8-hour average.
  2. Calibrate personal sampling pumps before and after each shift and record flow rates; method NIOSH 2532 specifies media, flow, and analysis.
  3. Compare analytical results to the OSHA PEL of 0.2 ppm and the NIOSH REL. Document the higher of the two for internal exposure-control targets.
  4. Where the PEL includes a “skin” notation, dermal absorption can contribute to the dose — glove selection and hygiene facilities are part of compliance.

Frequently Asked Questions

What is the OSHA PEL for Glutaraldehyde?

The OSHA Permissible Exposure Limit (8-hour TWA) for Glutaraldehyde is 0.2 ppm.

What is the CAS number for Glutaraldehyde?

The CAS Registry Number for Glutaraldehyde is 111-30-8.

What are the target organs for Glutaraldehyde?

The primary target organs are the Respiratory tract; eyes; skin.

How do you measure Glutaraldehyde in workplace air?

Use NIOSH analytical method NIOSH 2532 for air sampling and laboratory analysis.

What hazard class is Glutaraldehyde?

It is classified here as a Aldehyde (Aldehyde).

Related Aldehyde chemicals

Other aldehydes with lower or comparable exposure limits.