pellimits.com
CAS 7726-95-6Halogenated

Bromine

OSHA PEL 0.10 ppm· Halogenated Hydrocarbons · NIOSH method NIOSH 6011

OSHA PEL (8-hr TWA)
0.10 ppm
Target organs
Respiratory tract; eyes; skin
Sampling method
NIOSH 6011

Bromine (7726-95-6)

Bromine is a halogenated hydrocarbon with CAS Registry Number 7726-95-6. Under the OSHA air contaminants standard (29 CFR 1910.1000), its Permissible Exposure Limit (PEL) — the legal 8-hour time-weighted average (TWA) for general industry — is 0.1 ppm. The principal target organs are the Respiratory tract; eyes; skin, and workplace air is sampled and analyzed by NIOSH 6011.

Exposure Limits at a Glance

Limit Value Basis
OSHA PEL (8-hr TWA) 0.1 ppm 29 CFR 1910.1000
NIOSH REL See note below NIOSH Pocket Guide
Hazard Class Halogenated Hydrocarbon Halogenated
Target Organs Respiratory tract; eyes; skin NIOSH / OSHA
Sampling Method NIOSH 6011 NIOSH Manual of Analytical Methods

NIOSH REL note: NIOSH recommends the lowest feasible concentration (LOQ-based) for many chlorinated solvents. The REL is a non-regulatory recommendation; where a NIOSH REL exists it is typically more protective than the OSHA PEL.

How It Enters the Body & Health Effects

Exposure to Bromine is assessed against the Respiratory tract; eyes; skin — the organ systems most consistently affected in occupational studies. Employers must ensure no employee’s 8-hour TWA exceeds the 0.1 ppm PEL, and must use engineering controls, work practices, and — where required — respiratory protection to keep exposures at or below that level.

Sampling & Compliance Notes

  1. Determine whether the exposure is a full-period 8-hour TWA or a short-term / ceiling scenario. Ceiling and STEL excursions apply to several Halogenated-class agents regardless of the 8-hour average.
  2. Calibrate personal sampling pumps before and after each shift and record flow rates; method NIOSH 6011 specifies media, flow, and analysis.
  3. Compare analytical results to the OSHA PEL of 0.1 ppm and the NIOSH REL. Document the higher of the two for internal exposure-control targets.
  4. Where the PEL includes a “skin” notation, dermal absorption can contribute to the dose — glove selection and hygiene facilities are part of compliance.

Frequently Asked Questions

What is the OSHA PEL for Bromine?

The OSHA Permissible Exposure Limit (8-hour TWA) for Bromine is 0.1 ppm.

What is the CAS number for Bromine?

The CAS Registry Number for Bromine is 7726-95-6.

What are the target organs for Bromine?

The primary target organs are the Respiratory tract; eyes; skin.

How do you measure Bromine in workplace air?

Use NIOSH analytical method NIOSH 6011 for air sampling and laboratory analysis.

What hazard class is Bromine?

It is classified here as a Halogenated Hydrocarbon (Halogenated).

Related Halogenated chemicals

Other halogenated hydrocarbons with lower or comparable exposure limits.